SMOK Nord 5 Replacement Pod

These refillable replacement pods are built exclusively for the Smok Nord 5 kit — they won't fit the Nord 4, Nord 2, or anything else in the range, so make sure you've got the right device before ordering. Each pod holds 2ml of e-liquid, fully TPD compliant for the UK market. Compatible with the RPM 3 coil series, you've got two mesh options: the 0.15Ω for open, cloud-forward draws or the 0.23Ω for a more restrained DTL or restricted direct-to-lung setup. Side fill, push-fit coils, and an integrated coil lock keep day-to-day use straightforward.

Key Features

• TPD-Compliant 2ml Capacity – UK legal pod volume; the semi-transparent PETG shell lets you gauge liquid level at a glance
• Side Fill with Silicone Stopper – Pull out the bung, fill, push it back in. About 10 seconds, minimal mess
• Bottom Press-Fit Coil Slot – Takes the full RPM 3 mesh coil range; push until it clicks, no tools needed
• Integrated Coil Lock Clip – Secures the coil firmly in the base; reduces leak risk and stops the coil from dropping loose mid-session

Core Advantages

Coil Lock That Does Its Job

The locking clip on the pod base holds the RPM 3 coil securely in place. Earlier pods in this range were known to leak from a loose coil connection — this one clips shut. Users consistently report no flooding, even after accidental drops. Less clean-up, less wasted liquid.

One Pod, Two Coil Configurations

These pods accept both the 0.15Ω and 0.23Ω RPM 3 mesh coils, which means you can dial in the experience without swapping pods. Run the 0.15Ω at 50–65W for open, vapour-heavy DTL vaping. Drop to the 0.23Ω and tighten the airflow for a more controlled restricted draw at 20–40W. Decent flexibility from a single pod shell.

E-Liquid Recommendations

The Nord 5 pods are built for DTL and RDL styles, so liquid choice matters for these refillable pods:

• High VG (70%+ VG) — Shortfills and 100ml bottles are the go-to. Thick, smooth vapour with solid flavour at sub-ohm wattages.
• Freebase nicotine, 3–6mg — Keeps throat hit manageable when running the 0.15Ω at 50W+.
• Fruits & desserts — Flavour comes through well on mesh coils; berry, tropical, and custard profiles tend to shine.
• Menthol & cooling blends — Clean and refreshing through the wide-bore mouthpiece.

Avoid nic salts — the combination of high nicotine and sub-ohm wattage will be uncomfortably harsh.

Specifications

How To Use

1. Install the coil Push an RPM 3 coil firmly into the base of the pod until it seats fully. Engage the coil lock clip to secure it.
2. Prime the coil Drop 3–4 drops of e-liquid directly onto the coil's cotton before filling. Prevents a burnt first hit.
3. Fill the pod Locate the side fill port. Pull out the silicone stopper, fill slowly to the 2ml mark, and push the stopper firmly back in until flush.
4. Leave it to soak Let the pod stand for 3–5 minutes. Rushing this step is the main cause of dry hits.
5. Seat the pod on the device Push the pod down into the Nord 5 until the magnetic connection clicks. Power the device on, set your wattage, and vape.

FAQs

Are these pods compatible with the Smok Nord 4 or other Nord devices?

No. These pods fit the Smok Nord 5 kit only. The Nord 4 uses a different pod and coil system — not cross-compatible. If you're on a different Nord device, check the model before ordering.

Why does my pod have a cloudy or blocked section inside?

That's a silicone volume insert built into the pod to meet UK TPD regulations, capping the fill capacity at 2ml. It's not a fault or an air bubble — just the compliance restrictor.

How do I stop the Nord 5 pod from leaking?

Make sure the coil lock clip is fully engaged after installing the RPM 3 coil, and keep the silicone fill stopper firmly seated after filling. If liquid gets into the pod bay, remove the pod and wipe the contacts dry before reseating.

How long does a Nord 5 pod last?

Most vapers get several weeks from a single pod. The PETG shell holds up well to daily handling — expect to cycle through 2–3 coils before the pod shell itself needs swapping out.

What e-liquid works best with these pods?

70% VG or above. The DTL mesh coils need good liquid viscosity to wick properly at sub-ohm wattages. Thin, high-PG e-liquids can lead to dry hits, especially on the 0.15Ω coil.